Tools for building my guitars.
Before building the hole thing, I decided to do a little test setup to see if it would work like I think.
Two supplies with 24V and 34V for the controller and the servo.
The Novusun NVEM V2.
The JMC iHSV57 servo.
The schema for the hole wiring I drew on DigiKey Scheme-It.
A little video of the test wiring.
Got me a new tube tester made by Neuberger. The device is made in Germany in 1956.
The device can be configured by hole cards thad are made vor specific tube types. The holes in the cards shows positions vor the configuration pins thad route the appropriate voltages to the dedicated tube pins vor the chosen test on the switch. With the buttons on the left side of the configuration panel, the connection to the tube pins can be interrupted. This helps to find witch component is shorted in the tube. The device can perform a filament test, cathode, grid 1 to 4 and anode shortage test and also a emission measurement test.
A little demo video using the Neuberger RP270 tube tester.
To clean my SATA 5000 B HVLP Spray Gun a build my self a blowout station from plywood an battens. The top I covered with solvent resistant foil.
The design I made in Fusion 360. The files can be downloaded under https://a360.co/2GXckzk.
The hole build on Video:
For a proper neck set and bridge positioning on my guitar builds a want to build my one centerline finder. This project I designed in Autodesk Fusion 360. The files can be downloaded under http://a360.co/2awxJeE.
Continue reading Guitar centerline finder for neck set and bridge positioning